STEAM_WORKSHOP creator
grubisabug
10 projects across 1 game, 2.0k downloads in total.
- Projects
- 10
- Game
- 1
- Downloads
- 2.0k
- Last shipped
- 6 y ago
- Basic Pressure ControlAutomates room pressure control to keep pressure within a desired range. Uses an intake vent and an exhaust vent to keep air clean. An optional dial can be installed to control pressure, but is not required. Default pressure is set to 30Kpa.421 downloadsupdated 7 y ago
- Basic Solid Fuel GeneratorAutomates a solid fuel generator to turn on or off within a desired charge range of a stationary battery. Easily adjustable parameters for minimum and maximum charge ratios, default is to turn generator on at 20% battery charge and off at 50% battery charge. Device base stores value representing...349 downloadsupdated 7 y ago
- Solid Fuel Generator 2.0# Solid Fuel Generator 2.0 # By Scerius # # Automates a solid fuel generator to toggle power # within a desired battery charge range. Multiple # batteries supported, and can optionally manage # power generation and battery charge displays. # # Device 0 - Solid Fuel Generator # Device 1 - Batch Re...245 downloadsupdated 6 y ago
- Basic GasMixer ControlAutomates a gas mixer unit to power on/off at specfied pressure settings read from a pipe analyzer. Multiple mixers can be installed if desired.229 downloadsupdated 7 y ago
- Dual Axis Solar TrackingOnly requires a single daylight sensor, which can be installed in any orientation. Easily adjustable horizontal parameter to adjust solar panels if necessary. Resets panel orientation to face sunrise when the sun sets. This chip writes to memory units to allow for a batch writer to update any num...168 downloadsupdated 7 y ago
- Basic Filtration ControlThis chip will power on a filtration unit when a Pipe Analyser reports the gas specified by an installed filter has reached a specified value, and power it off again once it has filtered down to a specified amount. By default, the filtration unit will power on when the gas ratio in the pipe is at...153 downloadsupdated 7 y ago
- Basic Temperature ControlAutomates temperature control to keep temperature within a desired range. Can accept a wall heater, wall cooler, and dial, but none of these components are required. If you don't want a dial, or only need a heater, or only want a cooler, the versatility of this chip has it covered, while maintain...135 downloadsupdated 7 y ago
- Basic Tank FillSimple chip to automate filling something with pressure, such as a Tank or CanisterStorage (or anything that can report a pressure value and a device capable of pressure such as pump). Modify DesiredPressure value to preference, which controls how much pressure to fill. The device base itself use...129 downloadsupdated 7 y ago
- Basic FurnaceAutomates a basic furnace pressure and fuel. All components are optional, just plug in the ones you want. Use a logic reader to read the furnace pressure, and write it to the device base with a logic writer.123 downloadsupdated 6 y ago
- Basic Tank EmptySimple chip to automate removing pressure from something, such as a Tank or CanisterStorage (or anything that can report a pressure value and a device capable of pressure such as pump or vent). Modify DesiredPressure value to preference, which controls how much pressure to empty to. The device ba...81 downloadsupdated 7 y ago