348joey

Projects

17

Game

1

Downloads

4.4k

Best known for

Surge Alloy Smelter (x10)

637 downloads

Last shipped

4 y ago

• SSurge Alloy Smelter (x10)Basically half of the Surge Alloy Smelter (x20), but without an Overdrive Dome. The auxiliary lead input was removed since this isn't designed to run under an Overdrive Dome with two extra smelters tacked on. Based on637 downloadsupdated 6 y ago
• TTriple Phase Synthesizers (Self-Start)Input: 36 Sand/second (surge conveyor) 12 Thorium/second (duct) 24 Ozone/second (reinforced conduit) Output: 5.02 Phase Fabric/second Thorium may be input into either container or any phase synthesizer provided the four thorium duct unloaders are pointing in the correct directions. For sand, you'...501 downloadsupdated 4 y ago
• TT1-T5 Reconstructor (16x16)A fairly compact reconstructor design that can be used to create any unit desired. You may place a Naval, Ground, or Air Factory in the space provided. The lead input may be changed to coal for the crawler line, but the metaglass input is already set in such a way that it provides the T1 Factory...460 downloadsupdated 5 y ago
• DDisassembler & SorterThis version has a sorter attatched to the top. Uses ~38 scrap per second total, slightly less. 4 inputs at the bottom, 2 outputs at top. The bottom corner inputs need at least 10 scrap/sec. Any more than this will be rerouted to the inner belts. Tests showed 36 scrap/sec to be too little and 38...345 downloadsupdated 6 y ago
• TTileable Plastanium CompressorsRequires 10 titanium per second on each belt input and 150 oil per second on each conduit input for maximum efficiency. You can flip the conduit inputs to the top if desired, but adjacent conveyors need to go in the same direction. Any input that isn't titanium will be output along with the plast...295 downloadsupdated 5 y ago
• TTriple T1-T4 ReconstructorThis device will build one T4 unit of your choice every ~12 seconds . Simply place two of the corresponding factories in the spaces provided facing the Additive Reconstructor (T2) and select your unit (The Dagger, Crawler, and Flare lines only need one Factory). Change the Lead input on the left...236 downloadsupdated 5 y ago
• TT1-T5 Reconstructor (14x17)Technically 15x17, but the sorters are only there to show you what items to input where. This design is updated to be just as small as the old version but not require phase conveyors. Just add the basic Tier 1 Factory of choice in the provided space. Note that you must build over the lead and sil...223 downloadsupdated 5 y ago
• OOffensive Launch CoreLargely based off of Gheti's "POWER AND MEGAS" launch core. I rearranged a few things to allow a more versatile T1 Factory, in case you wanted to replace it with a ground factory and build the Nova Line (a handful of T3 Novas can easily take down a Medium Level enemy base, bypassing most of the b...222 downloadsupdated 6 y ago
• UUltimate Core-Based T-5 BuilderTrying to take an area and have lots of materials being launched into it but no accessible water, titanium, or power? This design will build you any ground unit you need (change the lower titanium unloader to coal for crawler line units). Built-in overdrive dome and water extractors. As long as t...214 downloadsupdated 6 y ago
• LLower-Tech Efficient Triple T3 BuilderNo armored belts, no phase conveyors, no cryofluid, no exotic processed materials. Unboosted, this factory will produce a T3 unit every 10 seconds (The Nova line may take longer). Who needs fancy tech when you have an army? This can easily overwhelm with sheer numbers while your opponent wastes t...205 downloadsupdated 5 y ago
• SSurge Alloy Smelter (x20)This design will function on its own as a 20 Smelter schematic, but you may also add the Alloy Smelter Add-on to increase it to 24 Smelters. Required input for max efficiency (x24): Base 38.4 Lead/sec on each side (76.8/sec total) Base 28.8 Copper & Silicon/sec on each side (57.6/sec of each mate...198 downloadsupdated 6 y ago
• CCCC (x6) Chemical Combusion ChambersInput: 3 full reinforced pumps of Arkycite (240/sec total) 1 Vent Condenser of Water (30/sec) Output: 3420 net Power/sec 13.5 net Hydrogen/sec (18 minus the 4.5 Hydrogen required to run pumps assuming you only use 3 pumps to get 240 Arkycite) Designed to be slotted around a vent condenser. Requir...196 downloadsupdated 4 y ago
• SSilicon Arc Furnance (x3)Input: 14.4 Sand/second 3.6 Graphite/second Output: 14.4 Silicon/second Nine cliff crushers fully on 150% yield (1.63/sec) walls will provide enough sand. Five unboosted plasma bores, two plasma bores with hydrogen, or one large plasma bore with nitrogen will give enough graphite. Sand and graphi...180 downloadsupdated 4 y ago
• BBlast Mixer (x6)Max Input: 4.5 spores & 4.5 Pyratite per second Max Output: 4.5/sec Blast Compound This is designed in such a way that clogs are easily fixed. If a clog occurs, either change the sorters to the type of item that is clogging it or replace the sorters with conveyor belts pointing at the adjacent br...158 downloadsupdated 6 y ago
• TT4&T5 Reconstructor Cryo MixerProvides enough cryofluid to fuel the Tetrative and Exponential Reconstructors (240/sec). Max Input: 240 water and 10 titanium per second Max Output: 240 cryofulid per second The five mixers on the right are for the Expo, but their bridge may be connected to the others and instead have a single l...116 downloadsupdated 6 y ago
• SSilicon Arc Furnaces (x20)Input*: ~96.39 sand/second ~14.46 (x2) graphite/second (~28.92 total) Output*: ~96.4 silicon/second *The speed at which a powered surge conveyor can deliver sand may vary. I could only reliably get a little under 95 sand/second to the furnaces, so I could only supply 19 of them fully or 18 fully...116 downloadsupdated 4 y ago
• DDisassembler (x5)Uses ~38 scrap per second total, slightly less. 4 inputs at the bottom, 2 outputs at top. The bottom corner inputs need at least 10 scrap/sec. Any more than this will be rerouted to the inner belts. Tests showed 36 scrap/sec to be too little and 38 scrap/sec was barely more than enough. For some...114 downloadsupdated 6 y ago

17 projects, most downloaded first. Each one has its own page here with what it needs to run and where its author publishes it; the files themselves stay with the author and are never re-hosted on this site.